| |
Facility:
Inventory:
- Wide selection
of cold finished bars including rounds, squares, hexes and flats
- Aluminum
bars, shapes, pipe, tubing and sheet
- Stainless
steel bar, shapes, pipe, tubing and sheet
- Hot rolled
structural shapes, rounds, flats and squares in 20’ and 40’
lengths
- HR plate
through 6” thick
- CR, HR,
HR P&O, galvanized and galvannealed steel sheet
- Standard
and flattened expanded metal in carbon, stainless and aluminum
- Round,
square and rectangular tubing
- A53 schedule
40 and 80 tested pipe through 12”
- Uncoated
pipe through 2”
- (NOTE:
All items listed may not be in stock but are available.)
Orlando's
racking system has
storage capacity for 780 locations |
Stock
Racks
|
Wide
Variety of Aluminum Rounds |
Quick
Pick Racks |
Processing
Services:
- Non-Ferrous
saws can cut hex, flats, tubing and shapes as well as rounds and squares
with:
- Precision
Sawing 3/8” up to 3 ½”
- Tighter
tolerances (+ or – 0.004”)
- Faster
Cutting
- Improved
Cut Finish
- Greatly
Reduced Burrs
- Flame
cutting 3/16” up to 8” thick plate
- Shearing
up to 144” wide
- Mild
steel: 20ga to ¼”
- Aluminum:
20ga to 3/8”
- Stainless:
up to 11ga
- 4 Bar
Saws for cutting:
- Up
to 21” rounds
- Miter
up to 14” x 45 degrees
- (NOTE: Additional
processing services available at other Alro locations)
10-torch
MG Burning Machine for
cutting plate up to 8" thick |
TSUNE
Non-Ferrous Precision Saw
|
Cut-off
Saw |
1/4"
x 12' Shear |
Driving
Directions:
- From I-4,
take East-West Expressway east to Semoran Blvd. (Rt.-436). Go down the
ramp to the 2nd traffic light, turn left and cross under the ramp. You
will be on Rt.-436 N. (Semoran Boulevard). Follow 436 to Colonial Drive
(Rt.-50). Turn right onto Colonial Drive to 1st traffic light (Forsyth
Road). Turn left onto Forsyth. Facility is approximately 1-1/2 miles
on the right.
- Click
here for Yahoo Driving Directions from your location.
|
